Absima Servo Programming USB Interface Adapter

Absima Servo Programming USB Interface Adapter

Product description and features

This USB adapter is compatible with programmable ABSIMA servos labelled “SMART SERVO”. 

Suitable for the following programmable Absima servos:

• ST23DBF Team Spec.
• ST50DBT Team Spec.
• LP16DBF Team Spec.
• LP20DBT Team Spec.
• ST18DBF Race Spec.
• ST40DBT Race Spec.
• LP15DBF Race Spec.
• LP19DBT Race Spec.
• LP34DBT Crawler Spec.
• ST62DBFT Crawler Spec. 

Applications

HV servo for model aeroplanes, helicopters, boats and RC cars.

Adjustable parameters

1. Servo angle: Setting the servo rotation angle
2. Servo neutral position: This is where the servo’s neutral position is set.
   Note: If the transmitter turns to the neutral position but the servo does not remain in the corresponding position, you can change this value to adjust the servo horn. This is equivalent to trimming the transmitter channel.
3. PWM Power: Set the servo output power. The higher the power, the higher the servo torque and speed; however, power consumption will also be higher.
4. Damping Factor: Set the servo damping.
5. Sensitivity: Adjust the dead zone (sensitivity) of the servo.
6. Soft Start: Slow recovery when the servo is switched on. Once the servo is switched on, it rotates gently to the position of the current input signal. Note: This function is designed to prevent damage caused by incorrect servo mounting when switching on.
7. Reversal: Setting for normal and reverse rotation of the servo.
8. Narrow Band: FUTABA-SR mode.
9. SANWA SSR: SANWA SSR mode. Note: Enable this function to support SANWA SSR high-speed mode. The servo angle may not be accurate and will need to be readjusted.
10. PPM Loss Protection: There are three signal loss protection functions to choose from.
        a. Release: No protection
        b. Hold Position: The position prior to signal loss is maintained.
        c. Return to neutral position: Return to the neutral position (1500 µs position).
11. Overload protection: Set the servo lock protection. There are three levels, which are activated by ticking the relevant box.
        Level 1: Set the start time and power value for the primary protection.
        Level 2: Set the start time and power value for the secondary protection.
        Level 3: Set the start time and power value for the tertiary protection.
        Note: The left-hand side is used to set the protection start-up time; the right-hand side is used to set the output power after the start-up protection is activated.
12. Servo information: Servo information. Including servo model, version date, firmware name.
        “Servo Name”: Servo model
        “Manufacture”: Servo version date
        “Firmware”: Servo firmware name

System requirements

Operating system: Windows XP, Vista, 7, 8, 10 (32/64-bit).
Power supply: Directly via USB (5V / 500mA).
Software: The necessary drivers and configuration tools are available on the Absima Download.

Scope of delivery

1 Absima Servo Programming USB Interface Adapter, 1 Suitable adapter cable for data transfer