- Description
- Documents
GRAUPNER switching module 10A
Product description and features
With the switching module 10 A you have the possibility to switch a load via a receiver slot/servo slot of the JETI Duplex receiver. The receiver slot of the JETI Duplex receiver is programmed to "digital output". This "digital output" is then controlled via a function (e.g. light) created in the transmitter with one channel. See the "Documents" tab for instructions on how to create the function with the appropriate channel and the receiver setting to "Digital output".
For example, if an Anti Collision Light is to be simulated, the "Light" function transmitter can also use a sequencer from the JETI Duplex transmitter.
The jumper is used to differentiate between power supply for the load via receiver (jumper set) or external power supply. (Jumper removed) With an external power supply via X3/X4, the jumper MUST be removed, otherwise the receiver, the components connected to the receiver and the switching module will be damaged! The consumer (motor, LED, light bulb, etc.) is connected to X1 / X2. No cables are soldered to the circuit board, so there is the possibility of different cable thicknesses and connector types.
The module can be attached to the model either with double-sided tape or with cable ties. During assembly, ensure that the circuit board does not bend and that the underside of the circuit board does not touch any other components (danger of short circuits). After soldering the cables to X1-X4, the enclosed heat-shrink tubing is pushed over the circuit board and shrunk with a hot-air gun. Own cable lengths and strengths can be used for X1-X4, depending on where the consumer is located.
Technical data
- Operating voltage 4.0 - 8.4V via receiver
- Switching current max. 10 A
- Switching voltage max. 20 V
- Dimensions 23 x 11 x 5 mm
- Weight 2g
- Control channels required 1x encoder or digital switch
Scope of delivery
1x GRAUPNER switch module 10A, 1x manual
