RGB LED strips
RGB LED strip with soldered cable for connection to the light control module Optotronix Aurora LCU EVO2 NightShow RGB (article no. OPT2002).
To connect the RGB LED strips to the light control module, you can use the RGB connection cable (item no. OPT8005) and for example, the 8-pin wing connector with pin header (item no. A85405) can be used.
If required, the approximately five meter long RGB LED strip can also be cut and thus adjusted to the desired length . Appropriate crop marks are attached to the RGB LED strip. After cutting the RGB LED strip, the RGB extension cable (item no. OPT8010) can be soldered to the solder pins of the cut cable.
scope of delivery
1x RGB LED strips, approx. 5m length
The LEDs are extremely bright, do not look directly into the light from a close distance! Damage to the retina can occur.