Para-RC Scale seat harness Noah complete with drive

Para-RC Scale seat harness Noah complete with drive

Product description

The scale seat belt Noah is not only a highlight in terms of appearance, you will also experience your entire system in a new way.

Since the motor is installed close to the center of gravity, only very low mass moments of inertia arise around all axes. The result is a very smooth flight behavior, so that it can be flown extremely smoothly and precisely. Thanks to an integrated ballast system, the optimal wing loading of the respective flown glider can be changed quickly depending on the weather. The flight system is delivered fully assembled of course "made in Germany". This means: GRP inlay, motor, motor conversion with long motor shaft, storage of remote shaft, motor controller, ballast system, XT60E1 connector, foam drawer for the batteries and the folding propeller driver are already pre-assembled. Two Hacker 2400mAh batteries are used, which are connected in parallel. This results in 4800mAh. The optimal design of the entire drive train, the resulting low currents and a high aerodynamic efficiency of the propeller ensure long flight times. The batteries are plugged into permanently installed XT60E1 plugs, which are screwed to the GRP inlay. This makes it easier to plug in the batteries and can be done with one hand.

The following components are already included and fully assembled upon delivery:

• GRP inlay
• Motor Hacker A40 10S V4 (inside)
• Long motor shaft
• Ball bearing mounted remote shaft
• YGE controller 65 LVT
• Ballast system
• Battery protection holder made of special foam
• Folding propeller driver
• GRP spacer for folding propeller
• Special folding propeller
• 2 XT60E1 plugs (screwed into the GRP inlay)
• Ballast system
• CFRP cooling air inlet plate
• CFRP cooling air outlet ring

Scope of delivery

1x Scale seat belt Noah, 1X GRP inlay, 1x ballast system holder with brass weights, 1x motor Hacker A40-10S V4 14-pole kv750, 1x remote shaft holder with ball bearings, 1x motor controller with telemetry YGE 65 LVT, 1x folding propeller holder, 1x GFK spacer for Folding propeller, 1x special folding propeller 14X8, 2x Hacker TF Power-X 2400-3S MTAG, 1x small parts bag, 1x assembly instructions

*not included: pilot, spinner, paraglider, servo lever, APS 360 °