Product description and features
The top model of the DITEX standard servos with 26 kilograms pulling load at 8.4 volts and a regulating time of 0.12 seconds for 60 degrees.
Transmission platform and housing of the servo form a unit because they were milled from the solid one-piece. So the servo brings a still higher holding force and convinces with more torque during startup.
Suggested application area
Large glider planes as well as engine models and jet models.
1 DITEX TD2612S, new servo armset 08.18 and fixing material.
The servo can be programmed with a PC or laptop by using the optionally available programming adapter Jeti USBa (see tab Accessories).
Permanent motor monitoring
Acoustic error indication directly from the servo. Exceeding or deceeding of set parameters (overload, mechanical blocking, overheat, undervoltage or signal error) are indicated by different acoustic signals directly from the servo.
Suitable e. g. for undervoltage indication when using long servo cables to the elevator or ailerons.
Error indication when reaching an arbitrarily programmed temperature e. g. with servos, which are installed near the torque tube of a turbine model.
Each feature of the monitoring messages is compatible with any RC system because error signaling takes place directly on the servo.
DITEX servo telemetry: If desired this servo values can be displayed also on the transmitter via JETI DUPLEX telemetry, as well as output as alarms and used and evaluated as telemetry transmitter.
Low power consumption through innovative motor control
Low holding current e. g. with flaps in the extended state.
Even at high speed low self-heating and thus less risk of overheating.
The servos can be operated directly with 2S LiPo/LiIon/LiFe supply.
Perfect servo distance and linkage
Precise positioning (angle degree) possible due to a hall sensor.
Zero position can be chosen chosen arbitrarily.
Reference: DITEX TD2612S used inside hightech drone
DITEX servos are also used outside the RC modelling scene. So the Dutch drone manufacturer HighEye uses DITEX TD2612S servos inside its long range UAVs. Read complete article on the Hacker Motor website...
|Recommended application area||Large glider planes as well as engine models and jet models.|
|Dimensions and weight|
|Weight incl. connection cable||75g (2.41oz)|
|Length connection cable||38cm (1.5in)|
|High voltage capable||yes|
|Voltage 1 (V1)||6V|
|Voltage 2 (V2)||8.4V|
|Regulating time V1/60°||0.17s|
|Regulating time V2/60°||0.12s|
|Pulling load V1||180 Ncm|
|Pulling load V2||265 Ncm|
|Frequency||55Hz to 333Hz|
|Number of output cogs||25 (Futaba/Savöx compatible)|